R&S RTO6 - Page 2373

Remote control commands
R&S
®
RTO6
2373User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:PCIE:DLLP:SEQ <SearchName>,<ACKNAKSequence>
SEARch:TRIGger:PCIE:DLLP:SEQ? <SearchName>
Sets the sequence field, indicating what TLPs are af
fected by the ACK/NAK, to be
searched for
, for the data link layer.
Parameters:
<ACKNAKSequence>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:TYPE <SearchName>,<Type>
SEARch:TRIGger:PCIE:DLLP:TYPE? <SearchName>
Sets the DLLP t type to be searched for
, for the data link layer.
Parameters:
<Type> ANY | MRDLLP | ACK | NAK | INITFC1 | INITFC2 | UPDATEFC |
PM | VENDOR
*RST
: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:VPAT <SearchName>,<VendorBtPatt>
SEARch:TRIGger:PCIE:DLLP:VP
AT? <SearchName>
Sets the vendor pattern to be searched for, for the data link layer.
Parameters:
<VendorBtPatt> 24-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:ERRC:CRC <SearchName>,<CRC16>
SEARch:TRIGger:PCIE:ERRC:CRC?
<SearchName>
Enables searching for 16-bit cyclic redundancy check (CRC) errors.
Parameters:
<CRC16> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols