R&S RTO6 - Page 2372

Remote control commands
R&S
®
RTO6
2372User Manual 1801.6687.02 ─ 05
Parameters:
<InitVHFC> ANY | YES | NO
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:MULT:VHGR <SearchName>,<ResetVHGroup>
SEARch:TRIGger:PCIE:DLLP:MULT
:VHGR? <SearchName>
Sets the virtual hierarchies group to be searched for, for the data link layer.
Parameters:
<ResetVHGroup> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE |
TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:MULT:VLNR <SearchName>,<V
irtualLink>
SEARch:TRIGger:PCIE:DLLP:MUL
T:VLNR? <SearchName>
Sets the virtual link (VL) number to be searched for, for the data link layer.
Parameters:
<VirtualLink> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:POWM <SearchName>,<PowerMngtType>
SEARch:TRIGger:PCIE:DLLP:POWM? <SearchName>
Sets the power management type to be searched for
, for the data link layer.
Parameters:
<PowerMngtType> ANY | ENTERL1 | ENTERL23 | ACTREQL1 | REQUESTACK
*RST: ANY
Parameters for setting and query:
<SearchName>
Protocols