R&S RTO6 - Page 2549

Remote control commands
R&S
®
RTO6
2549User Manual 1801.6687.02 ─ 05
POWer:RIPPle:RESult:PERiod[:ACTual]?.......................................................................
2553
POW
er:RIPPle:RESult:PERiod:AVG?.............................................................................2553
POWer:RIPPle:RESult:PERiod:EVTCount?.................................................................... 2553
POWer:RIPPle:RESult:PERiod:NPEak?.........................................................................2553
POWer:RIPPle:RESult:PERiod:PPEak?......................................................................... 2553
POWer:RIPPle:RESult:PERiod:RMS?............................................................................2553
POWer:RIPPle:RESult:PERiod:STDDev?.......................................................................2553
POWer:RIPPle:RESult:PERiod:WFMCount?...................................................................2553
POWer:RIPPle:RESult:STDDev[:ACTual]?..................................................................... 2554
POWer:RIPPle:RESult:STDDev:AVG?........................................................................... 2554
POWer:RIPPle:RESult:STDDev:EVTCount?...................................................................2554
POWer:RIPPle:RESult:STDDev:NPEak?........................................................................2554
POWer:RIPPle:RESult:STDDev:PPEak?........................................................................2554
POWer:RIPPle:RESult:STDDev:RMS?...........................................................................2554
POWer:RIPPle:RESult:STDDev:STDDev?......................................................................2554
POWer:RIPPle:RESult:STDDev:WFMCount?..................................................................2554
POWer:RIPPle:AUToscale <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:RIPPle:CURRent <TwoChMeas>
Activates or deactivates the input current.
Parameters:
<T
woChMeas> ON | OFF
*RST: ON
POWer:RIPPle:EXECute
Starts the ripple measurement.
Usage: Event
POWer:RIPPle:FREQuency <SmpsFrequency>
Sets the SMPS switching frequency.
Parameters:
<SmpsFrequency>
Range: 1 to 100E+9
Increment: 1
*RST: 1E+6
Default unit: Hz
Power analysis (option R&S RT
O6-K31)