Instrument setup
R&S
®
RTO6
82User Manual 1801.6687.02 ─ 05
Show / Source
Selects the souce of the label and enables the display
.
Remote command:
DISPlay:
SIGNal:LABel:SHOW on page 1310
Position mode
Defines the label position either relative to the diagram or with absolute values accord-
ing to the units of the waveform. Relative positions are fixed, whereas absolute posi-
tions move with the waveform display when the scales, the vertical position or offset, or
the reference point are changed.
The position mode applies to all labels of the selected waveform. For different wave-
forms, dif
ferent position modes can be selected.
"Relative"
Sets a fixed position in percent of the screen counting from the upper
left corner
.
"Absolute"
Sets the position in time and voltage values, or in other units depend-
ing on the waveform character.
Remote command:
DISPlay:SIGNal:LABel:POSMode on page 1307
Appearance settings
To Next Page
Loading...
