Remote control commands
R&S
®
RTO6
1414User Manual 1801.6687.02 ─ 05
ALL
All fields, triggers on the frame start (progressive scanning) or
field start (interlaced and progressive segmented frame scan-
ning)
ODD | EVEN
Only available for interlaced scanning and progressive segmen-
ted frame scanning. Triggers on the field start of the odd or even
field.
ALINe
All lines, triggers on all line starts.
LINE
T
riggers on a specified line. To set the line number, use
TRIGger<m>:TV:LINE. For NTSC signals, set also the field
with TRIGger<m>:TV:LFIeld.
*RST: ALL
Usage: Asynchronous command
TRIGger<m>:TV:POLarity <Polarity>
Sets the polarity of the signal. Note that the sync pulse has the opposite polarity, for
example, a positive signal has a negative sync pulse.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Polarity> POSitive | NEGative
*RST
: POSitive
Usage: Asynchronous command
TRIGger<m>:TV:LINE <LineNumber>
Specifies the line number to trigger on. The command is relevant if TRIGger<m>:TV:
MODE is set to LINe.
Usually the lines of the frame are counted beginning from the frame start. For NTSC
signals, the lines are counted per field, not per frame. For these signals, set also the
field with TRIGger<m>:TV:LFIeld.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<LineNumber>
Range: Depends on the standard, see table below
Increment: 1
*RST: 1
Trigger
To Next Page
Loading...
