R&S RTO6 - Page 1428

Remote control commands
R&S
®
RTO6
1428User Manual 1801.6687.02 ─ 05
TRIGger<m>:ECOupling <T
rigLevEvtCpl>
Event coupling of trigger levels: Sets the trigger levels to the values of the indicated
event. Thus, channel 1 has one trigger level for all events, channel 2 has one trigger
level and so on.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger
, 3 = R-trigger
Parameters:
<TrigLevEvtCpl> ON | OFF
*RST: ON
Usage: Asynchronous command
TRIGger<m>:SEQuence:DELay <Delay>
Sets the time the instrument waits after an A-event until it recognizes B-events.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<Delay> Range:
0 to 50
Increment: 1E-12
*RST: 0
Default unit: s
Usage: Asynchronous command
TRIGger<m>:SEQuence:COUNt <Events>
Sets the number of B-events to be fulfilled after an A-event. The last B-event causes
the trigger.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<Events> Range:
1 to 2147483647
Increment: 1
*RST: 1
Usage: Asynchronous command
TRIGger<m>:SEQuence:RESet:EVENt <EnabRstEvt>
If set to ON, the trigger sequence is restarted by the R-event if the specified number of
B-event does not occur.
Trigger