R&S RTO6 - Page 1427

Remote control commands
R&S
®
RTO6
1427User Manual 1801.6687.02 ─ 05
TRIGger<m>:SEQuence:RESet:EVENt..........................................................................
1428
TRIGger<m>:SEQuence:RESet:TIMeout[:ENABle]
..........................................................1429
TRIGger<m>:SEQuence:RESet:TIMeout:TIME............................................................... 1429
TRIGger<m>:EVENt[:EVENt] <Class>
Selects, if you want to trigger on a single event, or on a series of events.
Suffix:
<m>
.
1..3
Parameters:
<Class> SINGle | SEQuence
*RST: SINGle
Usage: Asynchronous command
TRIGger<m>:SEQuence:TYPE <Sequence>
Selects the type of the sequence. All trigger sequences require that input channels
CH1...4 are set as trigger sources for all conditions.
See also: Chapter 6.8, "Sequence", on page 229.
Suffix:
<m>
.
1..3
Irrelevant, omit the suffix.
Parameters:
<Sequence>
ABR | AZ | ABRZ | AORB | AORBZ
ABR
Triggers if all conditions of A- and B-events, as well as additional
delay and reset timeout or R-event (reset) conditions are fulfil-
led.
AZ
T
riggers if the conditions of the A-event and the zone trigger are
fulfilled. Additionally, a holdoff condition can be set.
ABRZ
Triggers if all conditions of A- and B-events, reset timeout or R-
event (reset) conditions are fulfilled for the defined zone.
AORB
Triggers if the conditions of A-event or the conditions of the B-
event are fulfilled.
AORBZ
Triggers if the conditions of A-event or the conditions of the B-
event are fulfilled for the defined zone. Additionally, a holdoff
condition can be set.
*RST: ABR
Usage: Asynchronous command
Trigger