R&S RTO6 - Page 1810

Remote control commands
R&S
®
RTO6
1810User Manual 1801.6687.02 ─ 05
EOFD: Wrong end of frame.
CAERror: CRC error followed by an acknowledgement error
(missing acknowledge)
FCERor: CRC error followed by a form error (wrong CRC delim-
iter or wrong ACK delimiter)
INSuf
ficient: The frame is not completely contained in the acqui-
sition. The acquired part of the frame is valid.
SERRror: Stuf
f count error (CAN-FD ISO only)
SFER: Stuff count error and FORM error (CAN-FD ISO only)
SCER: Stuff count error and CRC error (CAN-FD ISO only)
SAER: Stuff count error and ACK error (CAN-FD ISO only)
SCAE: Stuff count error and CRC error and ACK error (CAN-FD
ISO only)
SCFE: Stuff count error and CRC error and FORM error (CAN-
FD ISO only)
*RST: OK
Usage: Query only
BUS<m>:CAN:FRAMe<n>:NDBYtes?
REturns the number of data bytes.
Suffix:
<m>
.
1..4
<n> *
Return values:
<NDBytes> Range: 1 to 64
Increment: 1
*RST: 1
Usage: Query only
Firmware/software: FW 3.35
BUS<m>:CAN:FRAMe<n>:STARt?
BUS<m>:CAN:FRAMe<n>:ST
OP?
Return the start time and stop time of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Protocols