R&S RTO6 - Page 1501

Remote control commands
R&S
®
RTO6
1501User Manual 1801.6687.02 ─ 05
Parameters:
<ArithCstUnt> DBM | DB | DB_HZ | DB_GHZ | DBC | DBC_HZ | DBPW_HZ |
DBW |
DBPW | DBM_HZ | DBMW |
W | MW | W_HZ | J | V_S |
A_S | DBV | DBMV | DBMV_HZ | DBMV_MHZ | DBUV |
DBUV_HZ | DBUV_SQRT_HZ | DBUV_MHZ | DBUV_M |
DBMV_M_HZ | DBUV_M_MHZ | V | MV | UV | VPP | VV |
UV_HZ | UV_M_HZ | V_SQRT_HZ | DBA | DBMA | DBMA_HZ |
DBMA_MHZ | DBUA | DBUA_HZ | DBUA_SQRT_HZ |
DBUA_MHZ | DBUA_M | DBUA_M_HZ | DBUA_M_MHZ | A |
UA_HZ | UA_M_HZ | A_SQRT_HZ | PCT | DBPT | DBPT_HZ |
H | PH_GHZ | F | FF_GHZ | OHM | SIEMENS | S | DBPS |
DBNS | DBUS | DBMS | DBS | HZ | DBHZ | DBKHZ | DBMHZ |
DBGHZ | M | IN | DEG | RAD | PCT | SYMB | VA_LIN |
VA_LOG | NONE | IRE | MILES | SYMB_S | MSYMB_S |
MBIT_S | BIT_S | BIT | WORD | PPM | DB | PER_SEC | S_DIV |
HZ_DIV | V_DIV | A_DIV | OHM_DIV | NONE_DIV | DIV | BER |
S | S_S | BAUD | TDEG | VS | USER | UINV | W_DIV | V_V |
A_V | W_V | BYTS | V_A | V_W | VA | VAR | UI | LN
*RST: NONE
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:CUNState <ArithCustomNmeSt>
Enables the use of user-defined custom name for the amplitude/time arithmetic mea-
surement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<ArithCustomNmeSt>
ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:CUUNit <ArithCustomUnit>
Sets a user-defined value of the unit for the amplitude/time arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<ArithCustomUnit>
Usage: Asynchronous command
Automatic measurements