R&S RTO6 - Page 1502

Remote control commands
R&S
®
RTO6
1502User Manual 1801.6687.02 ─ 05
MEASurement<m>:AMPTime:ARIThmetic:CUUState <ArithCustomUntSt>
Enables the use of user-defined custom unit for the amplitude/time arithmetic measure-
ment. Y
ou can set the unit with
MEASurement<m>:AMPTime:ARIThmetic:CUUNit.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<ArithCustomUntSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:OPERator <ArithOperator>
Selects the operation type to be performed on the selected operands for the amplitude/
time arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<ArithOperator>
ADD | SUB | MUL | DIV
*RST: ADD
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:AMPTime
<ArithOp1MeasAmplitudeTime>
Selects the amplitude/time arithmetics measurements for the measurment group.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..2
Selects the operand.
Automatic measurements