R&S RTO6 - Page 1500

Remote control commands
R&S
®
RTO6
1500User Manual 1801.6687.02 ─ 05
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:GROup...................................
1503
MEASurement<m>:
AMPTime:ARIThmetic:PARameter<n>:SPECtrum...............................1503
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:TYPE......................................1504
MEASurement<m>:SPECtrum:ARIThmetic:CONStant.....................................................1504
MEASurement<m>:SPECtrum:ARIThmetic:COUNit.........................................................1505
MEASurement<m>:SPECtrum:ARIThmetic:CUNState..................................................... 1505
MEASurement<m>:SPECtrum:ARIThmetic:CUUNit.........................................................1505
MEASurement<m>:SPECtrum:ARIThmetic:CUUState..................................................... 1506
MEASurement<m>:SPECtrum:ARIThmetic:OPERator.....................................................1506
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:AMPTime...............................1506
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:GROup..................................1507
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:SPECtrum............................. 1507
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:TYPE.................................... 1508
MEASurement<m>:AMPTime:ARIThmetic:CONStant <ArithConstant>
Sets a constant numeric value as the second operand of the amplitude/time arithmetic
measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<ArithConstant>
Range: 0 to 0
Increment: 1
*RST: 0
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:COUNit <ArithCstUnt>
Selects the operation type to be performed on the selected operands for the amplitude/
time arithmetic measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Automatic measurements