R&S RTO6 - Page 1507

Remote control commands
R&S
®
RTO6
1507User Manual 1801.6687.02 ─ 05
Parameters:
<Op1MeasAmpTime> HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS |
STDDev | POV
ershoot | NOVershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SETup | HOLD | SHT |
SHR | CCJitter | NCJitter | CCWidth | CCDutycycle | TIE |
UINTerval | DRATe | SKWDelay | SKWPhase | DTOTrigger |
PROBemeter | SLERising | SLEFalling | ATAR
*RST: HIGH
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:GROup
<ArithOp2MeasGroup>
Sets the measurement group for the second operand of the spectrum arithmetic mea-
surement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
<n> 2
Parameters:
<ArithOp2MeasGroup>
MEAS1 | MEAS2 | MEAS3 | MEAS4 | MEAS5 | MEAS6 |
MEAS7 | MEAS8 |
IMEAS |
IMEas | QUICK | QUICk
*RST: MEAS1
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:PARameter<n>:SPECtrum
<ArithOp1MeasSpectrum>
Selects the first operand for the sepctrum arithmetics measurements.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 1..2
Selects the operand.
Automatic measurements