R&S RTO6 - Page 1504

Remote control commands
R&S
®
RTO6
1504User Manual 1801.6687.02 ─ 05
Parameters:
<Op1MeasSpectrum>CPOWer | ACPower | OBWidth | SBWidth | TOI | AMMod |
THD | THDPCT |
THDPct | THDA |
THDU | THDR | PLISt |
HAR | THDF | SPAR
*RST: CPOWer
Usage: Asynchronous command
MEASurement<m>:AMPTime:ARIThmetic:PARameter<n>:TYPE <ArithOp2Type>
Sets the type of amplitude arithmetic measurement.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
<n> 2
Parameters:
<ArithOp2T
ype> MEASurement | CONStant
MEASurement
Performs an arithmetic operation between two measurement
results.
CONStant
Performs an operation between a measurement result and a
user defined fixed constant.
*RST: MEASurement
Usage: Asynchronous command
MEASurement<m>:SPECtrum:ARIThmetic:CONStant <ArithConstant>
Sets a constant numeric value as the second operand of the spectrum arithmetic mea-
surement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<ArithConstant>
Range: - 3.4 e38 to + 3.4 e38
Increment: 1
*RST: 0
Usage: Asynchronous command
Automatic measurements