R&S RTO6 - Page 1632

Remote control commands
R&S
®
RTO6
1632User Manual 1801.6687.02 ─ 05
SEARch:GATE:MODE <SearchName>,<Mode>
SEARch:GA
TE:MODE?
<SearchName>
Defines whether the gate settings are configured using absolute or relative values.
Parameters:
<Mode> ABS | REL
*RST: ABS
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:SHOW <SearchName>,<DisplayState>
SEARch:GATE:SHOW? <SearchName>
If enabled, the gate area is indicated in the source diagram.
Parameters:
<DisplayState> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:ABSolute:STARt <SearchName>,<Start>
SEARch:GATE:ABSolute:ST
ARt? <SearchName>
Defines the starting value for the gate.
Parameters:
<Start> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:GATE:ABSolute:STOP <SearchName>,<Stop>
SEARch:GATE:ABSolute:ST
OP? <SearchName>
Defines the end value for the gate.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Search