Remote control commands
R&S
®
RTO6
1877User Manual 1801.6687.02 ─ 05
Parameters:
<DataPatternTo> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:FLXRay:SYMBol
<Symbol>
Triggers on a symbol or on a wakeup pattern.
Parameters:
<Symbol> CASMts |
WAKeup
CASMts
Collision Avoidance Symbol / Media access T
est Symbol. These
symbols are identical and can be sent in the optional symbol
window at the end of a communication cycle. They are used to
avoid collisions during the system start.
WAKeup
The wakeup pattern is sent to activate the nodes of the system.
*RST: CASMts
TRIGger<m>:FLXRay:BSSerror <BSSError>
Triggers on error in SyteStart Sequence. The BSS is transmitted before each byte.
Parameters:
<BSSError>
ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FESerror <FESError>
Triggers on error in Frame End Sequence. FES indicates the end of each frame.
Parameters:
<FESError>
ON | OFF
*RST: ON
TRIGger<m>:FLXRay:FSSerror <FSSError>
T
riggers on Error in a Frame Start Sequence. FSS follows the T
ransmission Start
Sequence TSS at the beginning of each frame.
Parameters:
<FSSError> ON | OFF
*RST: ON
Protocols
To Next Page
Loading...
