R&S RTO6 - Page 1304

Remote control commands
R&S
®
RTO6
1304User Manual 1801.6687.02 ─ 05
Example:
LAYout:ADD 'Diagram2',TAB,ON,C4W1,'MyDiagram3'
Creates a new diagram 'MyDiagram3' with waveform C4W1 in a
new tab that in front of 'Diagram2'.
Example: See Chapter 24.3.1.1, "Creating diagrams (SmartGrid)",
on page 1260.
Usage: Setting only
Asynchronous command
LA
Yout:REMove <DiagramName>
Closes the specified diagram. The waveforms are displayed as minimized waveforms
in their signal icons on the signal bar.
Setting parameters:
<DiagramName>
String with the name of the diagram
Usage: Setting only
Asynchronous command
LAYout:SHOW <DiagramName>
Selects the specified diagram.
Setting parameters:
<DiagramName> String with the name of the diagram
Example: See Chapter 24.3.1.1, "Creating diagrams (SmartGrid)",
on page 1260.
Usage: Setting only
Asynchronous command
LAYout:SIGNal:ASSign <DiagramName>, <Source>
Shows the specified waveform in the selected diagram.
Instrument setup