R&S RTO6 - Page 1515

Remote control commands
R&S
®
RTO6
1515User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
<n> 12 | 13
12: Peak list measurements
13: Harmonic search measurements
Parameters:
<MaxNoOfResults>
Range: 1 to 1000
Increment: 1
*RST: 10
Usage: Asynchronous command
MEASurement<m>:SPECtrum:RESult<n>:MODE <ResultMode>
Sets the way how the measurement results are displayed. A
vailable only if
MEASurement:
MAIN is set to PLISt or HAR.
Suffix:
<m>
.
1..10
<n> 12 | 13
12: Peak list measurements
13: Harmonic search measurements
Parameters:
<ResultMode> ABS | REL
ABS
The harmonics/peaks are shown in absolute value, dBm.
REL
The level of the carrier is shown in absolute value dBm. The val-
ues the harmonics/peaks are shown relatively to the carrier in
dBc.
*RST: ABS
Example:
:MEASurement1:SPECtrum:RESult13:MODE ABS
The harmonic measurements are shown in absolute value, dBm.
Usage: Asynchronous command
MEASurement<m>:RESult:MAXCount <Number>
MEASurement<m>:RESult:
MAXCount? <MeasType>
Defines the maximum number of peaks that are labeled in the diagram.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Automatic measurements