EasyManua.ls Logo

R&S RTO6 - Page 1570

R&S RTO6
2677 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
RTO6
1570User Manual 1801.6687.02 ─ 05
Various different window functions are provided in the R&S R
T
O6 to suit different input
signals. Each of the window functions has specific characteristics, including some
advantages and some trade-offs. These characteristics need to be considered carefully
to find the optimum solution for the measurement task.
Suffix:
<m>
.
1..8
math waveform
Parameters:
<WindowType> RECTangular | HAMMing | HANN | BLACkharris | GAUSsian |
FLATT
OP2 | FLATtop2 | KAISerbessel
RECTangular
The rectangular window has the best frequency resolution, but a
poor amplitude accuracy and is recommended for separating
two tones with almost equal amplitudes and a small frequency
distance.
HAMMing
The Hamming window is bell shaped and has a good frequency
resolution and fair amplitude accuracy. It is recommended for
frequency response measurements as well as sine waves, peri-
odic signals and narrow-band noise
HANN
The Hann window is bell shaped and has a slightly worse fre-
quency resolution but smaller sidelobe level than the Hamming
window. The applications are the same.
BLACkharris
The Blackman window is bell shaped and has a poor frequency
resolution, but very good amplitude accuracy. It is recommended
mainly for signals with single frequencies to detect harmonics.
GAUSsian
Good frequiency resolution and best magnitude resolution, rec-
ommended for weak signals and short duration
FLATTOP2 = FLATtop2
The flattop window has a poor frequency resolution, but the best
amplitude accuracy and the sharpest side lobe. It is recommen-
ded for accurate single-tone amplitude measurements.
KAISerbessel
The Kaiser-Bessel window has a fair frequency resolution and
good amplitude accuracy, and a very high sidelobe level. It is
recommended for separating two tones with differing amplitudes
and a small frequency distance.
*RST: BLACkharris
Usage: Asynchronous command
Firmware/software: Version 3.35 and higher: Use FLATTOP2 or FLATtop2 instead of
FLA
T2
Spectrum analysis

Table of Contents

Other manuals for R&S RTO6

Related product manuals