R&S RTO6 - Page 1587

Remote control commands
R&S
®
RTO6
1587User Manual 1801.6687.02 ─ 05
MTESt:SEGMent:POINt:COUNt?...................................................................................1589
MTESt:SEGMent:
POINt:X
.............................................................................................1590
MTESt:SEGMent:POINt:Y.............................................................................................1590
MTESt:SEGMent:RESCale:RECalculate........................................................................ 1590
MTESt:SEGMent:RESCale:XFACtor..............................................................................1591
MTESt:SEGMent:RESCale:YFACtor..............................................................................1591
MTESt:SEGMent:RESCale:XOFFset............................................................................. 1591
MTESt:SEGMent:RESCale:YOFFset............................................................................. 1592
MTESt:SEGMent:STATe <MaskTestName>, <MaskSegmIdx>,<State>
MTESt:SEGMent:STATe? <MaskTestName>, <MaskSegmIdx>
Enables and disables the mask segment. Disabled segments are not considered by
running tests.
Parameters:
<State> ON | OFF
*RST: ON
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
<MaskSegmIdx> Number of the segment. Counting starts from 0.
Usage: Asynchronous command
MTESt:SEGMent:ADD <MaskTestName>
Creates a new segment in the mask definition.
Setting parameters:
<MaskT
estName> String with the name of the mask test
Example: See Chapter 24.3.3.1, "Creating a user mask", on page 1265
Usage: Setting only
Asynchronous command
MTESt:SEGMent:COUNt? <MaskT
estName>
Returns the number of segments in the mask definition
Query parameters:
<MaskT
estName> String with the name of the mask test
Return values:
<Count> Number of segments
Usage: Query only
MTESt:SEGMent:INSert <MaskTestName>, <MaskSegmIdx>
Inserts a new segment before the specified index in the mask definition.
Mask testing