R&S RTO6 - Page 1615

Remote control commands
R&S
®
RTO6
1615User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:SLEWrate:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:SLEW
rate:SLOPe?
<SearchName>
Selects the edge type.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 24.4.3, "Slope parameter", on page 1285.
*RST
: POSitive
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:SLEWrate:TIME <SearchName>,<Time>
SEARch:TRIGger:SLEW
rate:TIME? <SearchName>
For the ranges "Within" and "Outside", the slew rate defines the center of a range
which is defined by the limits "±Delta".
For the ranges "Shorter" and "Longer", the slew rate defines the maximum and mini-
mum slew rate limits, respectively.
The range is defined using SEARch:TRIGger:SLEWrate:RANGe.
Parameters:
<Time> Range: 100E-12 to 864
Increment: 100E-9
*RST: 100E-12
Default unit: s
Parameters for setting and query:
<SearchName> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:LEVel:TRANsition:LOWer <SearchName>, <SignalSource>,
<V
alue>
SEARch:TRIGger:LEV
el:TRANsition:LOWer? <Key>, <SignalSource>
SEARch:TRIGger:LEVel:TRANsition:UPPer <SearchName>, <SignalSource>,
<Value>
SEARch:TRIGger:LEVel:TRANsition:UPPer? <Key>, <SignalSource>
Set the lower and upper voltage thresholds, respectively. When the signal crosses this
level, the slew rate measurement starts or stops depending on the selected slope.
Parameters:
<Value> Voltage value
Parameters for setting and query:
<SearchName> String with the name of the search
Search