R&S RTO6 - Page 1625

Remote control commands
R&S
®
RTO6
1625User Manual 1801.6687.02 ─ 05
NOT
Input value is inverted
Parameters for setting and query:
<Searchname> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:PATTern:AB:LOGic <Searchname>, <Operator>
SEARch:TRIGger:PA
TTern:AB:LOGic? <Searchname>
SEARch:TRIGger:PATTern:CD:LOGic <Searchname>, <Operator>
SEARch:TRIGger:PATTern:CD:LOGic? <Searchname>
SEARch:TRIGger:PATTern:ABCD:LOGic <Searchname>, <Operator>
SEARch:TRIGger:PATTern:ABCD:LOGic? <Searchname>
Defines the logical combination of the indicated channels after evaluating the previous
logical operations:
●
AB: CH1 and CH2
●
CD: CH3 and CH4
●
ABCD: result of AB and CD
Parameters:
<Operator> AND | NAND | OR | NOR
AND: logical AND, conjunctive combination
NAND:logical NOT AND
OR:logical OR, disjunctive combination
NOR: logical NOT OR
Parameters for setting and query:
<Searchname> String with the name of the search
Usage: Asynchronous command
SEARch:TRIGger:PATTern:MODE <SearchName>,<Mode>
SEARch:TRIGger:PA
TTern:MODE? <SearchName>
Adds additional time limitation to the pattern definition.
Parameters:
<Mode> OFF | TIMeout | WIDTh
OFF
No time limitation. The event is found if the pattern condition is
fulfilled.
TIMeout
Defines how long the result of the pattern condition stays high or
low
. The duration of the timeout is defined using SEARch:
TRIGger:
PATTern:TIMeout[:TIME] The result state is
defined using SEARch:TRIGger:PATTern:TIMeout:MODE.
Search