R&S RTO6 - Page 1738

Remote control commands
R&S
®
RTO6
1738User Manual 1801.6687.02 ─ 05
For details, see Chapter 13.5.2.1, "Audio signal configuration", on page
531.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<AudioV
ariant> I2S | LJ | RJ | TDM
I2S: Inter-IC Sound standard audio format.
LJ: left-justified data format
RJ: right-justified data format
TDM: Time Division Multiplexed audio format
*RST
: I2S
BUS<m>:I2S:CLOCk:SOURce <ClockSource>
Selects the source of the clock line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ClockSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Digital channels require installation of R&S RTO6-B1. Digital
and analog channels cannot be used at the same time. For trig-
gering on a serial bus, analog or digital input channels are
required.
*RST: C1W1
BUS<m>:I2S:CLOCk:POLarity <BitClockEdge>
Sets the polarity of the clock signal, that is the edge at which the instrument samples
the data on the data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<BitClockEdge> FALLing | RISing
*RST: RISing
BUS<m>:I2S:WSELect:SOURce <WSsource>
Selects the source of the word select line for I²S standard, left- und right-justified data
formats, or the source of the frame synchronization pulse for TDM audio signals.
Protocols