R&S RTO6 - Page 1872

Remote control commands
R&S
®
RTO6
1872User Manual 1801.6687.02 ─ 05
TRIGger<m>:FLXRay:PLPReamble <PayloadPreamble>
T
riggers on the payload preamble indicator bit that indicates a Network Management
V
ector in the payload segment.
Parameters:
<PayloadPreamble> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
TRIGger<m>:FLXRay:NUFRame <NullFrame>
Triggers on the null frame indicator bit, a frame without usable data.
Parameters:
<NullFrame>
ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
TRIGger<m>:FLXRay:SYFRame <SyncFrame>
Triggers on the sync frame used for synchronization of the FlexRay system. Only sync
nodes can send this frame type.
Parameters:
<SyncFrame>
ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
TRIGger<m>:FLXRay:STFRame <StartupFrame>
Triggers on startup frames used for startup of the network. Only specific start nodes
can send this frame type.
Parameters:
<StartupFrame>
ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
TRIGger<m>:FLXRay:FCONdition <IdOperator>
Sets the operator to set a frame ID or a frame ID range.
Parameters:
<IdOperator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The frame ID is not relevant for the trigger condition.
Protocols