R&S RTO6 - Page 2087

Remote control commands
R&S
®
RTO6
2087User Manual 1801.6687.02 ─ 05
BUS<m>:HBTO:ATTN <Attenuation>
Sets the attenuation factor
. It is used to de-amplify the reverse signal before subtract-
ing it from the forward signal.
Suffix:
<m>
.
1..4
Parameters:
<Attenuation>
Range: -100 to 0
Increment: 0.1
*RST: -26
Default unit: dB
BUS<m>:HBTO:FDAM <SourceDAminus>
Selects the DA- source of the provided forward single ended signal, if BUS<m>:HBTO:
FTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceDAminus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 |
R4
*RST: C2W1
BUS<m>:HBTO:FDAP <SourceDAplus>
Selects the DA+ source of the provided forward single ended signal, if BUS<m>:HBTO:
FTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceDAplus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 |
R4
*RST: C1W1
BUS<m>:HBTO:FDIF <SrcDif
f>
Sets the source of the provided forward dif
ferential signal, if BUS<m>:HBTO:FTYP is
set to DIFFerential.
Suffix:
<m>
.
1..4
Protocols