R&S RTO6 - Page 223

Triggers
R&S
®
RTO6
223User Manual 1801.6687.02 ─ 05
Hysteresis mode
Selects how the hysteresis is set.
"Auto"
Automatic hysteresis is the recommended mode. The hysteresis is
set by the instrument to reject the internal noise of the instrument.
"Manual"
The hysteresis is defined directly in absolute or relative values.
Remote command:
TRIGger<m>:LEVel<n>:NOISe[:STATe] on page 1424
Size mode
Selects whether the hysteresis is defined in absolute or relative values. The setting is
available only in manual hysteresis mode.
Remote command:
TRIGger<m>:LEVel<n>:NOISe:MODE on page 1425
Absolute hysteresis
Defines a range in absolute values around the trigger level. If the signal jitters inside
this range and crosses the trigger level, no trigger event occurs.
Remote command:
TRIGger<m>:LEVel<n>:NOISe:ABSolute on page 1425
Conditioning