R&S RTO6 - Page 2333

Remote control commands
R&S
®
RTO6
2333User Manual 1801.6687.02 ─ 05
Parameters:
<ThresholdHigh> Range: -10 to 10
Increment: 1E-3
*RST: 0.15
Default unit: V
BUS<m>:EBTB:DIFFerential:THRLow <ThresholdLow>
Sets the low threshold of the signal, if BUS<m>:EBTB:TYPE DIFFerential.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdLow>
Range: -10 to 10
Increment: 1E-3
*RST: -0.15
Default unit: V
BUS<m>:EBTB:DISF <DisplayFormat>
Selects the display format for the results in the decode table and for the results of
BUS<m>:EBTB:SYMBol<n>:
DATA?.
Suffix:
<m>
.
1..4
Parameters:
<DisplayFormat> KD | EB | TB
KD: K/D codes
EB: 8-bit pattern
TB: 10-bit pattern
*RST: KD
BUS<m>:EBTB:DMINus:SOURce <SourceDminus>
Selects the D- source of the provided single ended signal, if BUS<m>:EBTB:
TYPE
SINGle is set.
Suffix:
<m>
.
1..4
Parameters:
<SourceDminus> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 |
M5 | M6 | M7 | M8 | R1 | R2 | R3 | R4
Usage: Asynchronous command
BUS<m>:EBTB:DMINus:THReshold <ThresholdDminus>
Sets the low threshold (D-) of the signal, if BUS<m>:EBTB:TYPE SINGle.
Protocols