R&S RTO6 - Page 235

Triggers
R&S
®
RTO6
235User Manual 1801.6687.02 ─ 05
Logical trigger condition
If all required mask tests and zones are defined, you can type the logical expression
directly, or use the trigger condition editor
. All logical combinations are available in the
editor. To express the "Must Not Intersect" condition, use the logic NOT.
Remote command:
TRIGger<m>:ZONE:EXPRession[:DEFine] on page 1433
Apply zone trigger to history
Applies the zone trigger condition to the acquisitions in the history memory.
The history saves all acquisitions that fulfill the trigger condition that is set during acqui-
sition (zone trigger condition, or another trigger condition). If "Apply zone trigger to his-
tory" is disabled, the history "Play" reads and displays all saved acquisitions from the
memory.
If the setting is enabled, the zone trigger is applied to the history replay. "Play" displays
only acquisitions that fulfill the zone trigger condition.
Using "Apply zone trigger to history", you can:
●
Acquire waveforms with high speed and filter them afterwards in the history.
●
Change the zone trigger condition after acquisition.
Remote command:
SWTRigger:HISTory on page 1433
Zone trigger