R&S RTO6 - Page 2496

Remote control commands
R&S
®
RTO6
2496User Manual 1801.6687.02 ─ 05
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:COMPonents<n>:SPECtrum <State>
Enables a spectrum diagram for the selected measurement component.
Suffix:
<m>
.
1..2
<n> 1..29
See Table 24-20
Parameters:
<State> ON |
OFF
*RST: OFF
ADVJitter<m>:RESult:COMPonents<n>:TRACk <State>
Enables a track for the advanced jitter measurements.
Suffix:
<m>
.
1..2
<n> 1..29
See T
able 24-20
Parameters:
<State> ON |
OFF
*RST: OFF
ADVJitter<m>:RESult:UNIT <UnitType>
Selects between the absolute and relative unit for the displayed results.
Suffix:
<m>
.
1..2
Parameters:
<UnitT
ype> ABS | REL
*RST: ABS
ADVJitter<m>:RESult:COMPonents<n>:STATistics:MAXPeakpeak? <PeakValue>
ADVJitter<m>:
RESult:COMPonents<n>:STATistics:MAXStddev? <StdDevValue>
ADVJitter<m>:RESult:COMPonents<n>:STATistics[:MINStddev]? <StdDevValue>
ADVJitter<m>:RESult:COMPonents<n>:STATistics:MINPeakpeak? <PeakValue>
ADVJitter<m>:RESult:COMPonents<n>:STATistics:PEAKpeak?
Jitter analysis and clock data recovery