R&S RTO6 - Page 40

To Next Page

To Previous Page

Getting started

R&S

RTO6

40User Manual 1801.6687.02 ─ 05

Press the [Intensity] key and turn the [Multiuse] knob. Press the [Intensity] key again to

toggle between the three settings. The controlled parameter and its value are shown in

the input box in the upper right corner of the screen.

[Cursor]

Starts a cursor measurement: displays vertical and horizontal cursor lines in the active

diagram, and the results of the cursor measurement.

If you press the key while a cursor measurement is enabled, the "Cursors" dialog

opens. The next press closes the dialog.

Cursors are markers which are placed at points of interest on a waveform. The instru-

ment measures the cursor positions and delta values between parallel cursors.

[Measure]

Opens and closes the

"Measurements" dialog and the subtab of the last used mea-

surement. In the dialog, you can configure and start automatic measurements.

[History]

Opens and closes the history player. The history shows stored acquisitions that were

acquired before the current one.

The key is illuminated as long as history acquisitions are displayed.

[HD]

Activates the high definition mode and opens the "HD Mode"

dialog box.

[Autoset]

The instrument analyzes the enabled channel signals, and adjusts appropriate horizon-

tal, vertical, and trigger settings to display stable waveforms.

[Preset]

Resets the instrument to a predefined state and starts the continuous acquisition. All

measurements, mask tests, zoom, and most individual settings are deleted, and all

channels except for channel 1 are disabled. Y

ou can define preset configurations and

save them to a file. The [Preset] key can be configured to set either factory defaults or

a user-defined preset configuration.

Camera

Performs the action that is assigned to the key in "Menu" > "Settings" > "Frontpanel" >

"Hardkeys". By default, the key saves a screenshot of the waveform display.

Other manuals for R&S RTO6