R&S RTO6 - Page 486

Protocol analysis
R&S
®
RTO6
486User Manual 1801.6687.02 ─ 05
RTO6-K540
Ethernet buses
Ethernet 10BASE-T and 100BASE-TX Chapter 13.15.2, "Ethernet config-
uration", on page
727
MDIO Chapter 13.16.2, "MDIO configu-
ration"
, on page 743
RTO6-K550
MIPI low speed buses
MIPI RFFE Chapter 13.17.2, "RFFE configu-
ration", on page 757
RTO6-K560
Automotive ethernet
Ethernet 100BASE-T1 Chapter 13.18.2, "100BASE-T1
configuration", on page 777
RTO6-K570
USB buses
USB Chapter 13.20.2, "USB 2.0 config-
uration", on page 818
USB 3.1 Chapter 13.21.2, "USB 3.1 config-
uration", on page 848
USB PD Chapter 13.22.2, "USBPD config-
uration", on page 863
USB SSIC Chapter 13.24.2, "M-PHY configu-
ration", on page 893
RTO6-K580
MIPI M-PHY, D-PHY, C-
PHY Buses
MIPI D-PHY Chapter 13.23.2, "D-PHY configu-
ration", on page 875
MIPI M-PHY Chapter 13.24, "M-PHY and USB
SSIC (option R&S RTO6-K580
and K570)", on page 891
RTO6-K590
PCI express
8b/10b Chapter 13.25.2, "8b/10b configu-
ration", on page 922
PCIe Chapter 13.26.2, "PCIe configura-
tion"
, on page 937
Make sure that the tab of the correct serial bus is selected.
Protocol
Defines the protocol type of the selected serial bus.
Remote command:
BUS<m>:TYPE on page 1670
Decode
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
Remote command:
BUS<m>[:STATe] on page 1670
Basics of protocol analysis