R&S RTO6 - Page 788

Protocol analysis
R&S
®
RTO6
788User Manual 1801.6687.02 ─ 05
Decode Results Table
The results are shown in two tables:
●
"Decode results"
: contains information about all decoded frames
●
"Details frame": contains more detailed information about the selected frame in the
"Decode results"
table.
Table 13-28: Content of the Decode results table
Column Description
Frame Frame count
State Overall state of the frame: either OK or the relevant error condition (preamble,
CRC or SFD)
Start Start time of the frame
Type Type of frame (e.g. Idle, MAC or data)
Destination Destination address of the frame
Source Source address of the frame
Type/Length The sub-protocol (e.g. HTML, video, etc.) determines what meaning this field has.
Since the content of this data area is not decoded, the interpretation of this field is
ambivalent. It could either be the word type (specific for the sub-protocol) or the
word length.
CRC Frame Check (Cyclic Redundancy Code, CRC)
Destination symbol Symbol defined for the respective destination
Source symbol Symbol defined for the respective source
Bit rate Value of the bit rate
Table 13-29: Content of the Details frame table
Column Description
Name State of the field
Type Field type
Value Hexadecimal value of the field
Rcvr status Receiver status
Tools
Press "Display settings" in the "Decode Results"
table to access the "Display" tab.
Ethernet 100BASE-T1 (option R&S RT
O6-K560)