Protocol analysis
R&S
®
RTO6
851User Manual 1801.6687.02 ─ 05
CTLE
Continuous time linear equalization (CTLE) is an equalization that can be used for
improving the signal performance. It boosts the high frequency noise and the signal.
Thus it helps reduce the inter-symbol interference (ISI) on the reciever side.
Enable ← CTLE
Enables the CTLE equalization.
Remote command:
BUS<m>:
CTLE:ENBLe on page
2190
Zero frequency (fz) ← CTLE
Sets the zero frequency for the transfer function of the CTLE algorithm.
Remote command:
BUS<m>:CTLE:Z1FReq on page 2191
Pole frequency (wp1)/(wp2) ← CTLE
Sets the pole 1/2 frequency for the transfer function of the CTLE algorithm.
Remote command:
BUS<m>:CTLE:P1FReq on page 2190
BUS<m>:CTLE:P2FReq on page 2191
DC Gain (A
DC
) ← CTLE
Sets the adjustable DC gain. This value can be chosen according to the channel loss
characteristics. For low-loss channels, you can set a value close to 0 dB.
Remote command:
BUS<m>:CTLE:DCGain on page 2190
USB 3.1 (option R&S RT
O6-K570)
To Next Page
Loading...
