R&S RTO6 - Page 884

Protocol analysis
R&S
®
RTO6
884User Manual 1801.6687.02 ─ 05
"Data Min/
Data"
Specifies the value or sets the start value of a range.
"Data Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
For "Type">"HS Data":
TRIGger<m>:
DPHY:DATA:CONDition on page 2249
TRIGger<m>:DPHY:DATA:MAX on page 2250
TRIGger<m>:DPHY:DATA:MIN on page 2250
For "Type">"LP Escape Mode":
TRIGger<m>:DPHY:ESDTa:CONDition on page 2252
TRIGger<m>:DPHY:ESDTa:MAX on page 2253
TRIGger<m>:DPHY:ESDTa:MIN on page 2253
Data Index
Data index sets the range within this series of the data value that is considered for the
analysis. The data index setup consists of the condition and one or two data index val-
ues.
"Condition"
Sets the comparison condition to a specific value or a range.
"Index Min/Index"
Specifies the value or sets the start value of a range.
"Index Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
For "Type">"HS Data":
TRIGger<m>:
DPHY:DIDX:CONDition on page 2250
TRIGger<m>:DPHY:DIDX:MAX on page 2250
TRIGger<m>:DPHY:DIDX:MIN on page 2251
For "Type">"LP Escape Mode":
TRIGger<m>:DPHY:ESINdex:CONDition on page 2253
TRIGger<m>:DPHY:ESINdex:MAX on page 2254
TRIGger<m>:DPHY:ESINdex:MIN on page 2254
Escape mode
The escape mode setup consists of the condition and one or two data patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see Chapter 13.1.7, "Bit pattern editor",
on page 493.
"Condition"
Sets the comparison condition to a specific value or a range.
"Data Min/
Data"
Specifies the value or sets the start value of a range.
"Data Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
D-PHY (option R&S RT
O6-K580)