Protocol analysis
R&S
®
RTO6
943User Manual 1801.6687.02 ─ 05
Make sure that:
●
In the [Bus] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger type PCI express
Selects the trigger type for the PCI express analysis.
"TLP (Transac-
tion layer)"
Sets the trigger on a defined type of the transaction layer packet.
"DLLP (Data
link layer)"
Sets the trigger on a defined type of the data link layer packet.
"Ordered Sets"
Sets the trigger on a defined ordered set.
"Error Condi-
tion"
Sets the trigger on a selection of error conditions.
Remote command:
TRIGger<m>:PCIE:
TYPE on page 2359
TLP (Transaction layer)
Specifies the trigger conditions for the transaction layer type trigger.
TLP ← TLP (Transaction layer)
Triggers on a transaction type.
PCIe (option R&S RT
O6-K72)
To Next Page
Loading...
