R&S RTO6 - Page 983

Protocol analysis
R&S
®
RTO6
983User Manual 1801.6687.02 ─ 05
Remote command:
EYE<m>:
FILTer:BPATtern:
PREFix<1..8> on page 2415
EYE<m>:FILTer:BPATtern:CENTer on page 2415
EYE<m>:FILTer:BPATtern:SUFFix<1..5> on page 2415
Pattern control
Shift the pattern bit by bit to the left or to the right, and reset to the default (X for all
bits).
Remote command:
EYE<m>:FILTer:BPATtern:SLEFt on page 2415
EYE<m>:FILTer:BPATtern:SRIGht on page 2415
EYE<m>:FILTer:BPATtern:RESet on page 2415
Protocol filter settings
This setting is only available, if the Source is set to "SBx" and the "DDR" serial bus
analysis is enabled for the same bus.
Reset settings ← Protocol filter settings
Resets the current filter settings.
Frame Type ← Protocol filter settings
Selects which frame types contribute to the eye diagram, write frames, read frames or
any of them.
Remote command:
EYE<m>:
FILTer:DDR:FTYPe on page 2415
Length Error ← Protocol filter settings
If enabled, the length errors contribute to the eye diagram.
Remote command:
EYE<m>:FILTer:DDR:LENerror on page 2416
DDR (option R&S R
T
O6-K91 )