R&S RTO6 - Page 1092

Jitter analysis and clock data recovery
R&S
®
RTO6
1092User Manual 1801.6687.02 ─ 05
●
"Track": the measurement results over time for an acquired waveform. It is the
graphical interpretation of all measurement values of a single acquisition. Unlike
the histogram, it reveals trends of change in the analysis and preserves the timing
relationship of the measurement results to the signal.
●
"Spectrum": displays how the power of the signal is distributed over the frequency.
Remote command:
ADVJitter<m>:
RESult:
COMPonents<n>:HISTogram on page 2495
ADVJitter<m>:RESult:COMPonents<n>:TRACk on page 2496
ADVJitter<m>:RESult:COMPonents<n>:SPECtrum on page 2496
Unit
In the jitter results dialog, you can select the unit for the displayed results. The follow-
ing values are available:
●
For jitter measurements, you can select between absolute (seconds) and relative
(unit intervals) values.
●
For noise measurements, you can select between absolute (V) and relative (%)
values.
Remote command:
ADVJitter<m>:RESult:UNIT on page 2496
Advanced jitter and noise (option R&S R
T
O6- K133/K134)