R&S RTO6 - Page 1348

Remote control commands
R&S
®
RTO6
1348User Manual 1801.6687.02 ─ 05
REPort
Creates and saves a report of the current results.
PROBemode
Only available for R&S R
T
‑ZM probes. Changes the measure-
ment mode of the probe.
PRSetup
Opens the "Probes Setup" dialog box.
*RST: RCONtinuous
Usage: Asynchronous command
PROBe<m>:SETup:DISPlaydiff <DisplayDiff>
Selects the input voltages to be measured by the ProbeMeter of an R&S dif
ferential
active probe.
See also: "Differential active probes" on page 118.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<DisplayDiff> DIFFerential | SINGleended
DIFFerential
Measures dif
ferential and common mode voltages
SINGleended
Measures the voltage between the positive/negative signal
socket and the ground.
*RST
: DIFFerential
Usage: Asynchronous command
PROBe<m>:PMETer:VISibility <Visibility>
Activates the integrated R&S ProbeMeter of active R&S probes.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<Visibility> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: FW 2.25
Acquisition and setup