R&S RTO6 - Page 1416

Remote control commands
R&S
®
RTO6
1416User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..3
Only 1 = A-trigger
, 2 | 3 = not available. Can be omitted.
Parameters:
<ScanMode>
INTerlaced | PROGressive | SEGMented
SEGMented: Progressive segmented frame uses progressive
scanning to capture the frame, and interlaced scanning for trans-
mission and display.
*RST
: INTerlaced
Usage: Asynchronous command
TRIGger<m>:TV:CUSTom:LDURation <LinePeriod>
Sets the duration of a line, the time between two successive sync pulses. Only relevant
if TRIGger<m>:
TV:STANdard is set to CUSTom.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<LinePeriod>
Range: 1E-6 to 500E-6
Increment: 100E-9
*RST: 64E-6
Default unit: s
Usage: Asynchronous command
TRIGger<m>:TV:CUSTom:STYPe <SyncPulseType>
Sets the type of the sync pulse. Only relevant if
TRIGger<m>:TV:STANdard is set to
CUSTom.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<SyncPulseT
ype> BILevel | TRILevel
BILevel
Bi-level sync pulse, usually used in SDTV signals
TRILevel
Tri-level sync pulse, used in HDTV signals
*RST
: BILevel
Usage: Asynchronous command
Trigger