R&S RTO6 - Page 1455

Remote control commands
R&S
®
RTO6
1455User Manual 1801.6687.02 ─ 05
REFCurve<m>:MULTichannel:NAME <MltChImptPath>
Defines the path and the file to be imported. If not path is given, the default path
C:\Users\
Public\
Public Documents\Rohde-Schwarz\RTx\RefWaveforms
is used.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Parameters:
<MltChImptPath>
String with path and filename
Example: See REFCurve<m>:MULTichannel:
IMPort on page 1455.
Usage: Asynchronous command
REFCurve<m>:MULTichannel:IMPort <MltChImptWfmSel>
Assigns a waveform from the multichannel file to a reference waveform. To import all
waveforms that are in the file, you must assign each waveform to another reference
waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<MltChImptWfmSel> NONE | NONE | WF1 | WAVeform1 | WF2 | WAVeform2 | WF3 |
W
A
Veform3 | WF4 | WAVeform4
WF1 = WAVeform1, WF2 = WAVeform2, WF3 = WAVeform3,
WF4 = WAVeform4
Selects the waveform in the export file.
*RST: NONE
Example: Prerequisite: file RefCurve_2016-02-16_01.bin is a multi-
channel export with at least WF1, WF3 and WF4.
REFCurve:MULTichannel:NAME 'RefCurve_2016-02-16_01.bin'
REFCurve1:MULTichannel:IMPort WF1
REFCurve2:MULTichannel:IMPort WF3
REFCurve3:MULTichannel:IMPort WF4
REFCurve:MULTichannel:OPEN
Usage: Asynchronous command
Firmware/software: FW 3.20
REFCurve<m>:MULTichannel:OPEN
Loads the waveform data to the reference waveforms.
Waveform analysis