R&S RTO6 - Page 1469

Remote control commands
R&S
®
RTO6
1469User Manual 1801.6687.02 ─ 05
CURSor<m>:Y2Position...............................................................................................
1473
CURSor<m>:YCOupling............................................................................................... 1474
CURSor<m>:X1ENvelope.............................................................................................1474
CURSor<m>:
X2ENvelope.............................................................................................1475
CURSor<m>:LABel[:LABel]...........................................................................................1475
CURSor<m>:LABel:X<1..2>..........................................................................................1475
CURSor<m>:LABel:Y<1..2>..........................................................................................1476
CURSor<m>:SIAD....................................................................................................... 1476
CURSor<m>:STATe <State>
Switches the indicated cursor on or off.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CURSor<m>:AOFF
This command switches all cursors off.
Suffix:
<m>
.
The numeric suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:FUNCtion <Type>
Defines the type of the indicated cursor set.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<T
ype> HORizontal | VERTical | PAIRed
HORizontal
A pair of horizontal cursor lines.
VERT
ical
A pair of vertical cursor lines.
P
AIRed
Both vertical and horizontal cursor line pairs.
*RST: PAIRed
Usage: Asynchronous command
Cursor measurements