R&S RTO6 - Page 1478

Remote control commands
R&S
®
RTO6
1478User Manual 1801.6687.02 ─ 05
CURSor<m>:MAXimum:LEFT.......................................................................................
1478
CURSor<m>:
MAXimum:RIGHt......................................................................................1478
CURSor<m>:MAXimum:NEXT...................................................................................... 1479
CURSor<m>:FFT:SETCenter
Sets the center frequency to the frequency value that is measured at cursor line c1.
Suffix:
<m>
.
The suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:FFT:TOCenter
Sets the vertical cursor line c1 to the center frequency.
Suffix:
<m>
.
The suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:MAXimum[:PEAK]
Sets both cursors to the absolute peak value.
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:LEFT
Sets cursor 2 to the next maximum to the left of the current position.
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:RIGHt
Sets cursor 2 to the next peak to the right (from the current position).
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
Cursor measurements