R&S RTO6 - Page 151

Acquisition and waveform setup
R&S
®
RTO6
151User Manual 1801.6687.02 ─ 05
Figure 5-7: Probe setup for passive probe
The following shared probe settings are available:
●
"Type, Name, Bandwidth
" on page 146
●
"Detect AutoZero, Use AutoZero" on page 147
If a passive probe is connected, the probe attenuation is read out and shown in the
"Setup" tab:
●
"Probe unit, Auto attenuation" on page 148
If you need to change the unit or attenuation, change the "Mode" to "Manual" and enter
the correct values.
Mode........................................................................................................................... 151
Vertical unit, Attenuation, Gain....................................................................................152
Mode
Defines how the attenuation of a passive probe is set.
"Auto"
The instrument uses the values that are read out from the probe.
"Manual"
You can define the attenuation unit and value.
See: "V
ertical unit, Attenuation, Gain
" on page 152
Remote command:
PROBe<m>:SETup:ATTenuation:
MODE on page 1351
Probes