R&S RTO6 - Page 1519

Remote control commands
R&S
®
RTO6
1519User Manual 1801.6687.02 ─ 05
MEASurement<m>:OPTical:LCHeck<n>:LOWer:LIMit.....................................................
1520
MEASurement<m>:OPT
ical:LCHeck<n>:UPPer:LIMit...................................................... 1520
MEASurement<m>:OPTical:LCHeck<n>:LOWer:MARGin................................................ 1520
MEASurement<m>:OPTical:LCHeck<n>:UPPer:MARGin.................................................1520
MEASurement<m>:OPTical:LCHeck<n>:VALid............................................................... 1520
MEASurement<m>:OPTical:OMAMplitude:RELative:STARt <Start>
Sets the start value of the range for the optical modulation amplitude.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<Start> Range:
1 to 99
Increment: 0.1
*RST: 40
Default unit: %
Usage: Asynchronous command
MEASurement<m>:OPTical:OMAMplitude:RELative:STOP <Stop>
Sets the end value of the range for the optical modulation amplitude.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Stop> Range: 1 to 99
Increment: 0.1
*RST: 60
Default unit: %
Usage: Asynchronous command
MEASurement<m>:OPTical:UNIT <Unit>
Selects the unit for the optical measurements.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Unit> WATT | DBM
*RST: WATT
Automatic measurements