R&S RTO6 - Page 1541

Remote control commands
R&S
®
RTO6
1541User Manual 1801.6687.02 ─ 05
Parameters:
<FieldName>
MEASurement<m>:PROTocol:F2FRame:FRMFrom <FrameName>
Sets the type of start frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:F2FRame:FRMTo <FrameName>
Sets the type of end frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:F2FRame:VALFrom <FrmFrmFromVal>
Sets the field value of the start frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrmFrmFromV
al>
Usage: Asynchronous command
MEASurement<m>:PROTocol:F2FRame:VALTo <FrmFrmVal>
Sets the field value of the end frame for the frame to frame protocol measurement.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrmFrmV
al>
Automatic measurements