R&S RTO6 - Page 1543

Remote control commands
R&S
®
RTO6
1543User Manual 1801.6687.02 ─ 05
MEASurement<m>:PROTocol:MBITrate:FLD <FieldName>
Sets the type of field for the frame of the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:MBITrate:FRM <FrameName>
Sets the type frame for the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:MBITrate:VAL <MainBtRateIdVal>
Sets the field value of the frame for the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<MainBtRateIdV
al>
Usage: Asynchronous command
MEASurement<m>:PROTocol:SBITrate:FLD <FieldName>
Sets the type of field for the frame of the secondary bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:SBITrate:FRM <FrameName>
Sets the type frame for the secondary bit rate protocol measurement.
Automatic measurements