R&S RTO6 - Page 1547

Remote control commands
R&S
®
RTO6
1547User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
MEASurement<m>:GATE:MODE <Mode>
Defines whether the gate settings are configured using absolute or relative values.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<Mode> ABS |
REL
*RST: ABS
Usage: Asynchronous command
MEASurement<m>:GATE:ABSolute:STARt <Start>
MEASurement<m>:GA
TE:ABSolute:STOP <Stop>
Define the absolute start and end values for the gate.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<Stop> Range:
-100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Usage: Asynchronous command
MEASurement<m>:GATE:RELative:STARt <RelativeStart>
MEASurement<m>:GA
TE:RELative:STOP <RelativeStop>
Define the relative start and end values for the gate, respectively.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<RelativeStop>
Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Usage: Asynchronous command
Automatic measurements