R&S RTO6 - Page 163

Acquisition and waveform setup
R&S
®
RTO6
163User Manual 1801.6687.02 ─ 05
Figure 5-14: Probe setup for R&S
RT-ZD01
Specific settings for predefined probes are the following:
Predefined probe.........................................................................................................
163
Of
fset to mean.............................................................................................................164
Line impedance...........................................................................................................164
Predefined probe
List of probes that are known to the instrument. The instrument lists only probes that
match the instrument coupling and, if connected, also the used adapter.
Select the used probe on the list. The corresponding "Vertical unit" and the "Attenua-
tion" or "Gain" are shown.
All other unrecognized probes that are not listed, are unknown probes. For these
probes, set "Predefined probe" to "None". See Chapter 5.6.8, "Setup for unknown
probes", on page 167.
Remote command:
PROBe<m>:SETup:ATTenuation:DEFProbe on page 1361
Probes