R&S RTO6 - Page 1638

Remote control commands
R&S
®
RTO6
1638User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
SEARch:RESult:LIMit <SearchName>,<ResultListLimit>
SEARch:RESult:LIMit? <SearchName>
Defines the maximum number of entries in the search result table.
Parameters:
<ResultListLimit> Range: 1 to 1000
Increment: 1
*RST: 100
Parameters for setting and query:
<SearchName> Search definition
Example: See Chapter 24.3.4.1, "Searching for a pulse of specified width",
on page 1266
Usage: Asynchronous command
SEARch:RESult:SHOW <SearchName>,<ShowResultTable>
SEARch:RESult:SHOW?
<SearchName>
Displays or hides the search result table.
Parameters:
<ShowResultTable> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:RESult:SORT:ASCending <SearchName>,<SortAscending>
SEARch:RESult:SORT:ASCending?
<SearchName>
If enabled, the results are listed in asscending order, i.e. the smallest value at the top.
Parameters:
<SortAscending> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
Search