R&S RTO6 - Page 1639

Remote control commands
R&S
®
RTO6
1639User Manual 1801.6687.02 ─ 05
SEARch:RESult:SORT[:MODE] <SearchName>,<SortMode>
SEARch:RESult:SORT[:MODE]? <SearchName>
Sorts the search result table by x-value position or value of the result.
Parameters:
<SortMode> POSition | VALue
POSition
Sorts the search result table by the x-value position.
V
ALue
Sorts the search result table by the value of the result.
*RST
: POSition
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
SEARch:RESult[:ALL]? <SearchName>
Returns all search results.
Query parameters:
<SearchName> Search definition
Return values:
<Data> List of search results, separated by commas. For each result, six
values are returned:
1. Acquisition index, currently always 0.
2. X-position of the search result
3. Y
-position of the search result, currently not relevant
4. T
ype of the search result (Edge, Glitch, ...)
5. Slope or polarity of the search result
6. For runt, glitch, width, and window searches, the value con-
tains the width. For timeout and interval searches, it contains the
timeout. For transition searches, it contains the slew rate. For all
other searches, the value is not relevant.
If a value is not relevant, 9.91E+37 is returned.
Example:
SEAR:RES? 'Search1'
0,1.5375e-007,-84,Edge,Positive,9.91E+37,
0,5.3e-008,
-84,Edge,
Positive,9.91E+37
The query returns two search results for edge search on rising
edges at X-position 153,75 ns and 53 ns.
Usage: Query only
Asynchronous command
Search