R&S RTO6 - Page 1730

Remote control commands
R&S
®
RTO6
1730User Manual 1801.6687.02 ─ 05
BUS<m>:UART:BAUDrate <Bitrate>
Same as BUS<m>:
UART:BITRate.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range:
300 to 20000000
Increment: 1
*RST: 9600
Default unit: bps
Usage: Asynchronous command
BUS<m>:UART:PARity <Parity>
Defines the optional parity bit that is used for error detection.
See also: "Parity" on page 523.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Parity> NONE | ODD |
EVEN | MARK | SPC | DC
MARK
The parity bit is always a logic 1.
SPC
SPaCe: The parity bit is always a logic 0.
DC
Don't Care: the parity is ignored.
*RST: NONE
Usage: Asynchronous command
BUS<m>:UART:POLarity <Polarity>
Defines the idle state of the bus. The idle state corresponds to a logic 1. The transmit-
ted data on the bus is high (high = 1) or low (low = 1) active.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Polarity> IDLLow | IDLHigh
*RST: IDLHigh
Usage: Asynchronous command
Protocols